Will this fit over my factory fog light openings without modification?

The R34 design incorporates fog cutouts—verify your OEM bumper's fog hole diameter and location match this panel's openings before installation. If your holes sit lower or higher than the R34 profile, you may need minor trimming or hole relocation.

Does this bumper have factory sensor mounting provisions?

This panel is cut for a standard OEM sensor layout. Check your vehicle's bumper sensor location against the bumper cover's built-in provisions—if your car runs parking sensors, ensure the holes align before final assembly.

What should I do before painting?

Sand the surface with appropriate grit and wipe clean to remove dust. Apply your chosen basecoat and clear coat directly. Always mask off mounting tabs and edges before spraying to keep them bare for assembly.