Harrison Performance AF Fab A90 2 port Large runner Top mount Manifold and hot parts kit! 

Complete kit is Fit for GT35R size mid frame turbos with 4" Inlet / 2.5" outlet. (6466 or 6870 with T04SP Compressor Covers) with our charge pipe option. If you are Brave enough, our manifold itself will fit up to a 7675 with the T04HP compressor cover, but charge piping will not be a direct bolt on for the larger compressor cover.

3" Stainless Steel VBand down pipe with x2 o2 sensor bungs and fit for OEM Slip fit exhaust placement. Comes with Vband Clamp to Turbo

x2 Stainless Steel VBand wastegate dump tubes Down firing In front of down pipe

3" Stainless or Titanium Alloy Charge Pipe Material options with couplers and clamps

Fit for OEM Supra throttle body and Intake Manifold

Thick bead roll end for Coupler Fit to Turbo to keep the seal at high boost, Coupler and Clamps Included!

Sensor Bungs: OEM map sensor, OEM IAT sensor, x1 1/8 NPT Boost Sources come Standard, and optional 1/8 NPT methanol injection port by throttle body flange, and Nitrous Bung available as well.

Installation Tips: 

Removal and Plugging of the OEM Turbo's Water pump is required with our charge pipe

Turbo Blanket Is recommended for the Turbine Housing

*Install Manifold First, tighten all bolts well and use the OEM hardware and Gasket

*install Wastegates loosely onto the manifold and clamp the dump tubes loosely to the wastegates this will allow you to pivot the Vbands to align the Tips properly before tightening them in their final position.

*Bolt on the Turbo, add supplied Coupler and clamps to Turbo's Compressor Elbow

*install Down pipe from under the car to the OEM slip fit or Similar Fitting Exhaust and then clamp vband to turbo.

*install 02 sensors

* install Sensors onto Charge piping, slide charge piping into the coupler on the turbo and clamp.

*Bolt throttle body flange on the charge pipe to OEM throttle body